phantom power -4 mic inputs -schematic connections for. Every input and output is being used, except CR outs. features, lots of them, eq, compressor, buit-in FX, aux send/receiver, mute option, peak LEDs, etc. I'm looking at this behringer mixer on my desk used for recording (L/R busses are becoming more and more intermittent). Join Date: Jul 2006 Posts: 3334 Share Tweet 7. The smaller mixers make it hard since they use stereo channels with no eq, 2 sets per strip, tape inputs (who uses tape still?) that go toa switch then mains/control room outs. Behringer PMX5000 Behringer XENYX 1204FX Behringer XENYX 1622FX Behringer XENYX 2442FX. The more regular ol' MONO channels you board has the easier it is, you've got room to put just about anything in those main channels. Dit mengpaneel is perfect als een kleine live-performance audio mixer dan wel thuis opname set-up. Label your FX cables as SEND and RETURN as well. When you're dealing with a parallel effect (reverbs/delays etc are parallel, dynamics, comps,gates etc are serial) it is important to understand the that there is no relationship between aux send and aux return on a mixer, none. The 12-channel Behringer XENYX X1204USB is sure to be no exception, with 4 XENYX mic preamps with one-knob compression on each channel, with 24-bit digital effects, and an internal 2-channel USB audio interface to let you monitor and record your audio to your Mac or PC. I have long since switched from a SM7 to an RE20 for my own narration, which is a bit more sensitive than the SM7b on paper (1.5 mV/Pa versus 1.12 mV/Pa) and even with my conversational voice I only. Ex: if the FX AUX send is Aux 3, then the channel the FX return is routed to (ch15/16?) has Aux 3 turned down. 45 dB for a loud singer is often plenty (granted thats around max gain on some tube pres) This more or less lines up with my personal experience. I guess I should have said if you route the FX back into a channel (not aux return) make sure that channel has the FX AUX send turned down. Check out the 'Sound' section of the control panel. If aux is turned OFF, does it mean there will be signal going out to FX send? Re: Help with Behringer Xenyx 1204USB If youre using the 1/8' output of your PC, then dont use the USB cable, or you will have to tell the PC to use the internal sound card, not the USB one.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |